FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1823 total: showing 1601-1620)

Can the CR800 be programmed through either a mountable or portable keyboard display?
Is there an Ethernet module available for the CR800 or CR850?
What is the maximum current that the control port of a CR800, CR850, or CR1000 can source without causing damage?
Does the CR800 or CR850 work with a 2 kHz (maximum) burst mode for the VoltDiff() instruction like the CR1000 does?
Can the battery on the CR800 or CR850 be changed by the user?
How can several SDI-12 instruments be wired to a single data logger terminal?
Can a CR800 wiring panel be used on a data logger other than the original data logger?
What is the maximum supply voltage of a CR800 or CR850 without damaging the data logger?
Why do the example programs for the WXT520 use a scan rate of 5 seconds?
Why do the values from the WXT520 seem to be out of order?
If the wind speed on the WXT520 constantly reads 0, what should be done?
Is LoggerNet software needed to download the data from a data logger remotely?
Can the constants located within the ConstTable/EndConstTable instructions be edited?
Can the display timeout and contrast be programmed by the CRBasic Editor?
Can the CR800, CR850, CR1000, or CR3000 upload to an FTP site on scheduled intervals?
Is it possible to connect the CR800, CR850, CR1000, or CR3000 to a SCADA system through a Modbus RS-485 protocol?
How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU server?
Is it possible to overwrite an existing array using a CR850?
Can the NL201 be put into bridge mode via the settings of a CR800 or CR850?
Can the CR850 be programmed to show information in the display without using the keyboard?

Previous Next