FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1823 total: showing 1621-1640)

Can a new program be installed on a data logger using a laptop and PC200W?
When no excitation is commanded, are the voltage excitation ports on the data logger isolated from the data logger ground?
Instead of saving the data of a CRBasic data logger to one large file, how can it be saved in daily, hourly, or half-hourly files?
If a computer does not have any serial ports, how can software (such as LoggerNet, PC400, PC200W, or Device Configuration Utility) talk to the data logger?
Can external devices be switched on and off using a datalogger?
If a device or sensor is not available for selection in the Short Cut program, how can it be added?
Can the datalogger be damaged by wiring the sensors to the wrong ports?
How can a floating point value be cast as a long integer?
How can data that has been transmitted from a data logger to LoggerNet then be transmitted to a webhost that displays the data graphically?
Is there a way to only record measurements during the daytime and put the data logger in sleep mode during the nighttime to conserve power?
What is checked during the calibration of a Campbell Scientific data logger?
Is it possible to use LoggerNet Admin software to connect to, and display data from, multiple data loggers?
Can a datalogger be contained in a waterproof enclosure?
What does the PreserveVariables instruction do?
Can more than one SDM device be connected to a datalogger?
Can Campbell Scientific dataloggers be used with a telemetry system to remotely download data, check parameters, etc.?
Can binary data be received via the serial terminal of a data logger?
What might cause a CRBasic data logger to stop storing data?
How can the amount of time before the memory of a data logger is filled be calculated?
What are the rules regarding when data is deleted from a data logger?

Previous Next